Align document origin with registration marks: This will set the registration marks position on the document origin.Relative to media: This is to set the margin based on the media size.Relative to cut job: This is to set the margin based on the position of the cut job.Margin: This is the distance the registration marks are either from the design or the edge of the page.You can change the thickness (or stroke) of the line, but again, I find you get better, more consistent results if you do not change this setting. Thickness: This changes the width of the registration mark lines.You can make them smaller, but I find that you get better, more consistent results if you do not change this setting. By default it is set on the longest setting. Length: This changes how long your registration marks are.Units: This is where you set your unit of measurement.There are not many people around using a machine that was out before a Cameo, so most likely you will not change that field. ![]()
0 Comments
Leave a Reply. |